Forums
3D Printers Introdu...
3d printers
must have upgrades
Pellet Extruders te...
 
Notifications
Clear all

Pellet Extruders technology and article: 10 Tips for Converting a 3D Printer to Pellet Extrusion

 
Page 2 / 4
must have upgrades
Last Post by admin 5 years ago
17 Posts
1 Users
0 Reactions
1,011 Views
RSS
Posts: 447
 admin
Admin
Topic starter
December 10, 2020 2:07 am
(@admin)
Member
Joined: 6 years ago

In depth look at whats available for extruders, build types and installs.
lots of information and research to help guide you through the buy or build
process. The forum is building a hi-temp 3d printer that utilizes a pellet extruder built from plans and acquired parts.

https://makezine.com/2020/11/25/10-tips-for-converting-a-3d-printer-to-pellet-extrusion/

https://www.fabbaloo.com/blog/2018/4/17/are-pellets-better-than-filament


This topic is also published as an article here »
This topic was modified 5 years ago 8 times by admin
16 Replies
Posts: 447
 admin
Admin
Topic starter
December 12, 2020 12:00 am
(@admin)
Member
Joined: 6 years ago

Exploring more designs

1
2
3
Screen Shot 2020 12 11 at 6.58.43 PM
Screen Shot 2020 12 11 at 7.02.54 PM

This post was modified 5 years ago 2 times by admin
Reply
Posts: 447
 admin
Admin
Topic starter
December 12, 2020 12:09 am
(@admin)
Member
Joined: 6 years ago

 

Here is a scientific paper on build to test extruder

A Pellet 3D Printer: Device Design and Process Parameters Optimization

pellet science paper.pdf

 


This post was modified 5 years ago 2 times by admin
Reply
Posts: 447
 admin
Admin
Topic starter
December 12, 2020 12:55 am
(@admin)
Member
Joined: 6 years ago

 

 

 

Spitfire extruder, the Delta WASP 4070 

Screen Shot 2020 12 11 at 7.53.17 PM

Reply
Posts: 447
 admin
Admin
Topic starter
December 12, 2020 1:14 am
(@admin)
Member
Joined: 6 years ago

This is a complete guide for extruder setup including ramps and Marlin

Screen Shot 2020 12 11 at 8.11.00 PM

Excellant resource

screw info.pdf

   complete design, op specs, 

Great info for start-up

3.4 Flow Rate Output based on Screw Speed and Temperature


This post was modified 5 years ago 2 times by admin
Reply
Posts: 447
 admin
Admin
Topic starter
December 12, 2020 2:07 am
(@admin)
Member
Joined: 6 years ago

RepRap printed extruder

1

Reply
Page 2 / 4
Forum Jump:
  Previous Topic