Notifications
Clear all
October 27, 2020 4:06 pm
After 2 failed attempts to print this mount I used the default settings for supports and this is the result. looks like a useable part. now i can continue adding bl touch bed leveling to our new longer lk1
1 Reply
December 7, 2020 5:23 pm
Had an issue with bed leveling and putting out bad parts.
1 followed bed level instructions
2 changed print head
for some reason and I actually think it was the filament, the ender 5 was just not able to make parts.
This is a 4 hour run and looking good so
far