nice print today
3D Printer Parts Print
Overview
Started with a head fan mod print which turned out perfect.
Printer Troubleshooting
Problem
- Bed level issues
- Extruder not pushing material
- Printer bucking and popping
Solution
1. Cleaned the nozzle 2. Disassembled and cleaned the extruder head 3. Replaced the tube 4. Attempted firmware update (encountered issues with Arduino IDE) 5. Installed Uptanium bed level kit - Contacted Uptanium support for install files - Used commands: `m502`, `m851 z0`, `m500`, `g28`, `m851 z-x.xx` - Installed Marlin 2.01 firmware directly from `.hex` file
Notes
- Uptanium bed level kit significantly improved printer performance
- Direct firmware installation without Arduino IDE was successful
- Uptanium support was helpful
Uptanium Bed Level Kit
Summary
Installation of the Uptanium bed level kit resolved multiple issues with the Ender 5 printer.
Key Points
- Improved bed leveling
- Enhanced print quality
- Firmware update to Marlin 2.01
- Direct
.hexfile installation method - Uptanium support and resources were valuable
Print Quality Improvement
Overview
Print quality has improved over time.
Steps
- Initial prints were shaky
- Subsequent prints turned out better
Notes
- Continuous improvement in print quality observed