z axis mistake

Ender 5 Main Board Issue

Problem

• Nozzle on Ender 5 got clogged.
• Main board malfunctioned.
• Extruder motor turns when plugged into Z axis but a spare motor only bumps back and forth without forward progress.

Solution

• Consider replacing the silent Creality board with one where the driver can be removed.

Z Axis Retraction Issue

Problem

• Z axis retracts too fast, resulting in insufficient density of printed items.
• Issue persists even after bed leveling and software setup for Tevo.

Solution

• Check the 3 jumpers underneath the Z-motor driver (small green board next to the Z-motor connector) to ensure they all have caps on them.

Z Axis Endstop Sensor Installation

Problem

• Uncertainty about how to wire the sensor to the main board and where it gets power from.

Solution

• Plug the sensor directly into the Z-endstop socket on the motherboard.
• The sensor is tested to work with 5V, so no additional circuitry is needed.

Tarantula Printer Issues

Overview

• Issues with Tarantula printer after installing roller rails and dual screws.
• Output was not dense, with the X axis moving in too large of steps.

Solution

• Switched to an Ender 5 and installed auto leveling, which resolved the issue.
• Aim to get the Tarantula printer working again due to its sentimental value.

Ender 5 Silent Main Board Replacement

Problem

• Silent Creality board on Ender 5 malfunctioned after about 2 months.
• Attempted warranty but China-based manufacturer was uncooperative.

Solution

• Replaced the silent board with the original working board.
• Not recommended to purchase Ender 5 due to the issues encountered.