admin

This unit is printing, I've had issues with the hotend, having the 1lc canbus board on the head assembly just completes the way to big and bulky assembly specification. The expensive print head cloggs...

Attachment : IMG_1402.JPG Red fan clone bowden tube is 91.5mm as removed

Working on the hotend, dialing in the Stealthburner, this has taken several disassembles of the unit. m564 S0 H0 allow steppers to move without homingextruder run G1 E100 F60M563 P0 D0 extruder m84 re...

A number of concrete-only, or concrete-filled machines have been built by people over the years - there are even some YT vids available. I think the fundamental problem with using concrete is that Po...

Attachment : 1.png Attachment : 1.png Attachment : 1.png

It was recommended to upgrade the 8mm ball screw to 12mm and change out to servos. I can see the ball screws but I'm running duet control and that's stepper. maybe a larger stepper is being installed,...

lets look at some pieces As far as the base the idea was to place the y axis on top of the concrete base and then mold the z axis tower and attach it to the concrete base but if the vertical tower is ...

Attachment : base attach.png 4080 to attach to the new base, looks like a metal plate down the center 160mm wide would help distribute the 4080 beam load and give ample secure points. This was a q...

Not going at this blind i did some searches on the web for information on building the frame out of a concrete or epoxy concrete mix. To my surprise I found the epoxy information used playsand and 2 p...

First build, Attempt to stiffen it up and add some weight

To add to my printer stable I am building a PEKK capable printer

Attachment : The cross.png Stand with Jesus