admin

The latest foron 2.4 build is for PEKK

Attachment : crimp2.jpg Basic tools, wire stripper and end crimper. The end crimper is a slow process to begin with but once you do it a few times it just becomes a process, a slow one at that....

Going to create a tools catagory and tool usage to explain the terminal end builds on the Duet3 controller

This is my go to printer again. I just leave it on all the time, hit print and check it after a few hours , always a part. I think the full cage is what makes it so good, I almost sold this unit a co...

It is starting to become impossible to avoid. Battery technology is everywhere now and it's time to get a refresher on the technologies available and cover some issues with the use and safety. Batt...

Don't get caught up paying double price on amazon! If you read any posts on the forum you get the idea that we like to fix and build. Our 3d printing experience has us singing the prases of the long...

use the command M589 as shown below. Use double quotation marks, but substitute the SSID and WiFi password for your own WorkBee network. M589 S"your-machine-name" P"your-password" I-ip-adress As a pre...

Deciding to setup a backup board opened a can of worms, I tried to go through the update firmware using YAT and putting the files on the sd card, this failed and wasted at least an hour trying to reme...

I had a board with 2.1 firmware This is the beginning of the update Copy the new firmware binary file to the /firmware (if RRF 3.3beta1 or later is installed) or /sys folder (for earlier firmware v...

While your drone and controller are powered on and connected, but the motors aren’t turning, move the Proportional Control Rate Slider (on the right side of your controller) to the uppermost position....

I was a little deflated because I was ready to do some production runs and now this setting, one that I normally dred because your hooking up the computer to the duet and sending a specific instructio...

With everything in-place and a few prints completed (4) "T" fittings for some home made landing gear for a RC project, I decided to move the unit out to the production shop. Then the big shocker, a di...