Last seen: February 13, 2026 4:21 pm
settings for body upper previous print for battery box was successful on these settings
Started a new drone project required carbon fiber reinforced filament The prints are very large, right to the max dimension of this printer but ye...
It's all in the settings. Went from cura slicer to repietier, then back to cura to get this printing how i wanted. It's a learning process
This was before I converted all my machines to Duet WiFi controllers. I'll leave the links in case someone needs the files Did a firmware up...
This info from mahor design Firmware configuration Thermistor #define TEMP_SENSOR_0 1 Steps per millimeter of the motor (1/16 recommended) #de...
This info from mahor design Firmware configuration Thermistor #define TEMP_SENSOR_0 1 Steps per millimeter of the motor (1/16 recommended) #de...
1. Never fly beyond the operating range of temperatures. If you haven't noticed, the batteries get really hot after a flight and if you think you can ...
T-motor u8 135
Ok there is alot to unpack here. I finally gave up with the 2 hot-end blocks and made a heat element hot head. I found a 1.5 in copper bar and cut of ...
Every once in a while God throws me a bone. I have imagined this moment for the past week, at one point i figured it was never coming. The real issue ...