Forum

it is an assembly. Smooth. total bitch to install the bearing retainer cap. way to many screws and inserts.

it's been 6 weeks . This printer has pushed out some parts and really good ones. I had considered the bed level update but figured i would just see ...

thr price for a solid copper block was 40 bucks so i bought 2 copper heads from ebay for 10 and will try to setup 2 heaters this way. Looking through ...

Starting to assemble the extruder. Looks kinda rough, will probably reprint some of the parts 3d printers are running daily and parts coming off loo...

After drilling through the x-y carriage can be modular and replaced with a servicable unit, this is our strategy, to have modular components, built a...

This core x,y stuff is pretty cool

belt pulley build looking at the picture i notice i have the drive pulley backwards. i would say the driven pulley goes to the x axis but i dont k...

at this point I'm just wing'en it. used .020 safty wire to connect the belt at this point i just want to get an assembly, hope the belt holds gon...

Getting alignment and tightening the roller system. In order to get the rollors to not lock down you have to double nut the attaching screw. the se...

had to use button head screws to get the clearance for the pulley of course ball bearings laying around, wonder where they go?

This is my first attempt at cutting 1 panel, converting it from autocad to aspire. The aspire file won't upload i will provide a link. the cut file is...

Getting ready to start assembling the screw nozzle, inserts are all over it Tip #1 Heat set inserts Using a soldering iron turned to 343 °C (6...

Things look a little rough because this is a first build. I'm still wondering about a few things and also learning about others. the wood file ...