Forum

This is my go to printer again. I just leave it on all the time, hit print and check it after a few hours , always a part. I think the full cage is...

use the command M589 as shown below. Use double quotation marks, but substitute the SSID and WiFi password for your own WorkBee network. M589 S"your...

Deciding to setup a backup board opened a can of worms, I tried to go through the update firmware using YAT and putting the files on the sd card, this...

I had a board with 2.1 firmware This is the beginning of the update Copy the new firmware binary file to the /firmware (if RRF 3.3beta1 or later ...

I was a little deflated because I was ready to do some production runs and now this setting, one that I normally dred because your hooking up the comp...

With everything in-place and a few prints completed (4) "T" fittings for some home made landing gear for a RC project, I decided to move the unit out ...

to review: I installed the duet2 wifi on top of the ender control box, removing the ender power supply and securing it also to the top. I installed ...

; Configuration file for Duet WiFi (firmware version 3.3) ; executed by the firmware on start-up ; ; generated by RepRapFirmware Configuration Tool...

couple codes for setup m303 H0 s60 calibrate heat but also check it's performance m303 H1 s200 hotend ...

It took a couple attempts to get a complete print, it's not pretty but it has a purpose. I build raspberry pi security systems and print a stand for t...

M303 H0 S90 bed calibration