Last seen: February 13, 2026 4:21 pm
Ok so I errored by setting the cutoff voltage to 2.7. it appears there is an automatic cutoff in the battery, but there seems to be a relationship to ...
Lets recap and close this post The menu has to be accessed and data zeroed out between each test. There is wifi but it's useless there is usb co...
single lipo pack extracted from a battery pac
This is the next step, without spending hundreds this DL25 unit can be had for about 40 bucks. There is one with alot of unnecessary capibility but I ...
What about internal resistance and how can this be determined. I purchased a unit that looked promsing but further testing is required. The results we...
A CAN Network will consist of only two wires CAN High and CAN Low for bi-directional data transmission as shown above. Typically the communication spe...
The past couple days I have been working with the raspberry pi and install ubuntu and Pi os. what a blast. I'm up and running with 2 desktops as daily...
I have a working serial canbus adapter. I setup using a uno and seeed studio Serial CAN-Bus Module Based on MCP2551 and MCP2515 It's not the wave...
This is for the serial canbus setup I was able to get the keystudio mega with the CAN-BUS Shield V2 working, next is getting the can bus wi...
This was a fail, the requirements for this install are pi4 raspberry pi3 b install the os /p> setting up the can shield /p>
Assembled after printing the case, very clean. I combined all the parts into one print but I only added 1 base mount so I had to print 3 more