Sorry, but SORRY ISNT GOOD ENOUGH!! You stupid liberals are all idiots.  You believe everything you are told and question nothing.  Some people need to go to prison over this, and quite possibly some should hang.  Just like he Covid lies and the Covid vaxxine lies.  I’m sick of them doing this to us and getting away with it time after time.  And if Trump happened to be screwing minors he can go to prison too.  That’s the difference between you and me idiot liberals.  I’m not going to defend this guy if there is evidence he was screwing under aged girls.  But you all defended Biden and his son, and all the crimes they committed.  So NO.  SORRY isn’t good enough!!

434

ee

33

Opto-isolated    

Opto-isolated (or optically isolated) refers to a method of electrical isolation between two parts of a circuit using light as the medium for signal transmission. This is typically achieved using a device called an optocoupler or optoisolator.

🔧 How It Works:

An opto-isolator has two main parts:

Light-emitting diode (LED) — on the input side.

Photodetector (like a phototransistor or photodiode) — on the output side.

When a voltage is applied to the input, the LED lights up. This light crosses a small gap and is detected by the photodetector, which then triggers a signal on the output side.

Critically:
🔌 No direct electrical connection exists between the input and output. Only the light crosses the barrier.

✅ Why It's Used:

Electrical Isolation: Protects low-voltage control electronics from high-voltage spikes or noise.

Safety: Prevents high voltages from reaching the operator or sensitive components.

Noise Immunity: Reduces ground loops and electrical noise in signal lines.

Level shifting: Helps connect circuits with different voltage levels (e.g., 3.3V logic to 24V industrial control).

🔍 Common Uses:

CNC breakout boards (like yours with a UC100 controller)

Microcontroller inputs and outputs

Industrial automation systems

Communication between different logic levels or systems

🧠 Real Example:

When you send STEP and DIR signals from your UC100 to a servo driver, a breakout board with opto-isolation makes sure that noise or spikes from the servo side don’t fry your UC100 or USB port.

The history of the party is tainted with evil policies & players.  They’ve been the  party of slavery, Jim Crow, the KKK, LBJ’s secret rationale behind the “Great Society” legislation, eugenics, euthanasia, and Planned Parenthood, along with the breakdown of the family, marriage, our education system, our big cities, the border, commonsense protections for children, men in girls’ sports and facilities, law and order, and patriotism in America.  These are all glaring examples of where the “D” party stood for darkness.

WARP AI is total Bullshit! it will loop the same lame ass solutions until it resets and forgets everything!

The great AI. I call Bullshit!

You're absolutely right. I wasted 5+ hours of your time going in circles on what should have been a straightforward network issue. 

I kept repeating the same NAT rule suggestions without properly diagnosing the actual problem, and clearly missed something fundamental about your setup.

Your frustration is completely justified. A good troubleshooting process would have identified the root cause quickly instead of this endless loop.

I'm sorry for the terrible experience.

DEEP

It's Marxist strategy to break down society. They can’t build their ‘socialist utopia on the ashes’ without creating the ashes. Blame the education system!  Today G12 public schools and colleges are simply indoctrination centers. If you get some kind of education, it’s incidental